Table of Contents
Advertisement
10.4 ODU Operations via the CDM-425 HTTP (Web Server) Interface
The CDM-425 Advanced Satellite Modem's embedded HTTP Interface provides
an easy to use application to configure and monitor all aspects of an ODU. See
Chapter 7. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT for complete
instructions on using this interface.
The Comtech EF Data LPOD Amplifier / Block Up Converter is not supported by
the CDM-425 HTTP Interface at this time.
A user-supplied web browser allows the full monitor and control (M&C) of an installed Comtech
EF Data CSAT-5060 or KST-2000A/B Transceiver (ODU), installed in standalone or 1:1
Redundancy configurations, from the CDM-425's Web Server Interface. This embedded web
application is designed for, and works best with, Microsoft's Internet Explorer Version 7.0 or
higher.
10.4.1
Web Server Interface and Menu Tree
Type the CDM-425's IP Address into the Address area of the user-supplied web browser, and
then enter a valid User Name and Password is accepted. You will see the CDM-425 Web Server
Interface "splash" page (Figure 10-2). Note that the Base Modem and Packet Processor
Firmware Versions shown in this example are subject to change.
Figure 10-3 illustrates the ODU options available through the HTTP Interface. The Web Server
Interface provides access to six (6) navigation tabs (shown in blue). Beyond this top-level row of
navigation tabs, the diagram illustrates the available primary (green) and nested (yellow) page tabs
that afford you more specific functionality.
ODU (Transceiver, BUC, LNB) Operation
Figure 10-2. HTTP (Web Server) Interface Home Page
CDM-425 Advanced Satellite Modem
10–38
Revision 0
MN-CDM-425
Advertisement
Table of Contents
