Table of Contents
Advertisement
Use this page to configure the following overhead interfaces. See Appendix F. D
C
-
-C
ARRIER
IN
ARRIER
(CnC-APC) for complete details about, and setup of, the CnC-APC feature.
AUPC
(when Carrier-in-Carrier Automatic Power Control is disabled/de-activated)
•
AUPC: Use the drop down list to select disabled or enabled.
•
Rem Demod Target Eb/No: Enter a value between 0.0 and 14.9 dB.
•
Tx Power Max Increase: Use the drop down list to select a value 0-9 dB.
•
Max Pwr Reached Action: Use the drop down list to select No Action or Generate Tx
Alarm.
•
Rem Demod Unlock Action: Use the drop down list to select Go to Nominal Power or
Go to Maximum Power.
Click [Submit] to save.
CnC-APC
(when Carrier-in-Carrier Automatic Power Control is enabled/activated)
•
Tx Max Power Increase: Enter a value betwee 0.0 and 9.9 dB. Click [Submit].
•
APC Frame Sync: Click [Activate].
•
BER: Shows the BER number. Click [Reset BER].
•
FER: Shows the FER number. Click [Reset FER].
Click [Refresh].
EDMAC
Framing Mode and Slave Address
•
EDMAC Framing Mode: Use the drop down list to select EDMAC OFF, EDMAC Master,
or EDMAC Slave.
•
EDMAC Slave Address:
Click [Submit] to save.
Ethernet-based Remote Product Management
OPTION, See Sect. F.6 Carrier-in-Carrier Automatic Power Control
CDM-425 Advanced Satellite Modem
7–61
Revision 0
T
OUBLE
ALK
MN-CDM-425
Advertisement
Table of Contents
