Comtech EF Data CDM-425 Installation And Operation Manual page 513

10.3.3.3.3.2.2 ODU: FSK-control  2CSATs  Redundancy-Box
Red: Online: ODU2
TxSw:OK
This menu provides operating mode and switchover controls. You may also view the following
read-only information here:
•
Which of the two CSATs in currently online (ODU1 or ODU2);
•
Waveguide Switch Tx and Rx status: OK or Ft (fault);
•
Redundancy Controller Box 5V and 12V values (to aid trouble-shooting system
problems).
To set Operating Mode, use the ◄ ►arrow keys to select Mode, and then use the ▲▼ arrow
keys to select this mode as Auto or Manual:
•
AUTO mode – When the Online ODU faults, the switchover is done automatically to
replace the faulty unit.
If the ODU Redundancy system is in AUTO mode, a 'forced switch-over' can
only occur if the currently OFFLINE unit is fault-free.
•
MANUAL mode – If selecting the mode as Manual, there is no automatic switchover if a
fault occurs.
To force a switchover to the other CSAT unit, use the ◄ ►arrow keys to select Switch: N, and
then use the ▲▼ arrow keys to select Y (Yes). Press ENTER when done.
10.3.3.3.3.3 ODU: FSK-control  KST
KST Select:
Configuration
Use the ◄ ►arrow keys to select Configuration, Information, or Alarms, and then press
ENTER.
10.3.3.3.3.3.1 ODU: FSK-control  KST  Configuration
KST Config:
Use the ◄ ►arrow keys to select Tx, Rx, or Miscellaneous, and then press ENTER.
ODU (Transceiver, BUC, LNB) Operation
Mode:Auto
RxSw:OK
Information
Tx Rx Miscellaneous
CDM-425 Advanced Satellite Modem
Switch:N
5V:5.0 12V:12.0
Alarms ()
10–23
Revision 0
()
MN-CDM-425