Table of Contents
Advertisement
E.8
Drop and Insert (D&I) Clocking
Figure E-4 shows the general arrangement for D&I clocking in the CDM-425 Advanced Satellite
Modem. There are two inputs and two outputs shown for D&I Operation:
•
•
This arrangement permits you to choose between fully independent operation of the incoming and
outgoing E1/T1 signal, or to use the same T1/E1 signal for both Dropping and Inserting (looped
mode). If 'Loop' has been selected under the D&I configuration menu, the DDO signal is
automatically looped internally, to become the IDI.
In this mode, timeslots are dropped from an incoming E1/T1 signal for transmission over the
satellite, and the same E1/T1 signal has timeslots re-inserted into it that will over-write data in
existing timeslots.
Appendix E
Drop Data In (DDI)
Drop Data Out (DDO)
Figure E-4. Drop and Insert Clocking
CDM-425 Advanced Satellite Modem
•
Insert Data In (IDI)
•
Insert Data Out (IDO)
E–9
Revision 0
MN-CDM-425
Advertisement
Table of Contents
