Table of Contents
Advertisement
BERT Config
Use the drop-down lists provided in this section to configure Bit Error Rate Test for Tx or Rx as
On or Off; configure the pattern for Tx or Rx; and set Error Insertion as either Off or 10E-3.
Click [Submit BERT] once you select the desired BERT settings.
BERT Monitor
This read-only section displays the ongoing BERT. Click [Restart] to restart the BERT Monitor,
or [Update] to refresh a test already in progress.
Save / Load (Save takes precedence over Load)
The Save/Load feature stores and retrieves the CDM-425 Base Modem settings
only. It does not include the optional IP Packet Processor settings.
As a safeguard, to prevent any inadvertent action the Save Location and Load Location drop-
down lists' default selections are Don't Save and Don't Load, respectively. Otherwise:
•
Save Location / Load Location: se the drop-down lists to save or load up to 10 different
modem configurations – 0 through 9. An empty location is noted on its menu line as
Available.
Click [Submit Save/Load] to save.
Configuration | Utilities | Carrier ID
Appendix D. CARRIER ID (MetaCarrier®)
Ethernet-based Remote Product Management
Figure 7-32. Configuration | Utilities | Carrier ID Page
CDM-425 Advanced Satellite Modem
7–64
Revision 0
MN-CDM-425
Advertisement
Table of Contents
