Comtech EF Data CDM-425 Installation And Operation Manual page 294

Advanced satellite modem (18 kbps – 25 mbps)
Table of Contents

Advertisement

PTP
Feature:Use the drop-down list to set PTP operation as Enabled or Disabled.
o
o
Grandmaster: Use the drop-down list to assign from which port the PTP Grandmaster
receives messages: the LAN port or the WAN port.
Transport Mode: Use the drop-down list to select Unicast or Multicast:
o
o
Unicast Sync Interval: Use the drop‐down list to select the synchronization interval of
packets per second for messages sent from the Master to the Slave. Available selections
are:
1 message every 2
seconds
4 messages per second
32 messages per second
Click [Submit] to save.
Status
Click [Refresh] to update this section with its most recently accumulated statistics.
These status parameters are read-only and cannot be changed. Note the following:
Row
PTP Engine
Top
PTP Time
PTP Port
Middle
RTC Time
Bottom
PTP Domain
Ethernet-based Remote Product Management
If Enabled, PTP is used to establish independent Wireless Receiver/Transmitter
(WRT) protocol segments – one for LAN and the other for WAN.
If Disabled, by default the availability of the PTP protocol is dependent on the
near-end (e.g., the RNC/BSC) and distant-end (e.g., the BTS) IEEE 1588v2
(PTP) capable network devices in the network.
If you select Unicast, Unicast negotiation is enabled and the PTP Domain
number is set to 4.
If you select Multicast, Multicast negotiation is enabled and the PTP Domain
number is set to 0.
Use Unicast Sync Interval only when the Grandmaster is LAN port and the
Transport Mode is Unicast.
Title
Specifies whether or not PTP is actively attempting to synchronize time.
Displays the time that is synchronized with the master device and is being
propagated to the slave devices.
Displays whether or not the Ethernet link is detected. The PTP Port is always
Ethernet Port 2 on the modem.
Displays the presumed time for the modem. While the PTP time depends on the
Grandmaster device, the RTC Time changes only when set by the user.
Identifies the PTP Domain as '0' when in Multicast Transport Mode, or '4' when
in Unicast Transport Mode.
CDM-425 Advanced Satellite Modem
1 message per second
8 messages per
second
64 messages per
second
Description
7–70
Revision 0
2 messages per
second
16 messages per
second
MN-CDM-425

Advertisement

Table of Contents
loading

Table of Contents