Odu | Config - Comtech EF Data CDM-425 Installation And Operation Manual

ODU Comms
Use the drop-down list to select ODU operation as Disabled or Enabled, and then click
[Submit]. If you encounter a communications issue – e.g., an ODU is either physically not
present or the ODU Comms cable is not connected to the CDM-425 – the following error page
displays after clicking [Submit]:
Take steps to troubleshoot the ODU setup before attempting to enable ODU operations from this
page. See your pertinent ODU Installation and Operation Manual for further information.
10.4.2.4.2

ODU | Config

When you configure either the Comtech EF Data CSAT-5060 or KST-2000A/B as the ODU, you
may use this page to configure operating settings specific to the active unit. Otherwise, when you
attempt to access this page without first enabling ODU communications per the previous section,
the following error page displays:
ODU (Transceiver, BUC, LNB) Operation
Figure 10-8. ODU | Error Connection Message Page
Figure 10-9. ODU | Error Enable Message Page
10–45
CDM-425 Advanced Satellite Modem
MN-CDM-425
Revision 0