Table of Contents
Advertisement
Down Converter Parameters
•
Frequency – Enter a value in MHz.
•
Attenuation – Enter a value in dB.
•
Slope Mode – From the drop-down list, select Manual or Calibrated.
•
Slope Adjust (Manual Mode Only) – Select the desired setting from the drop-down list.
•
Mute – From the drop-down list, select Disable or Enable.
•
Gain Offset (1:1 Redundancy Only) – Select the desired setting from the drop-down
list.
Unit Parameters
•
Mute Mode – From the drop-down list, select Muted after freq change or Unmuted after
freq change.
•
Auto Fault Recovery, Cold Start, and Ext Reference Fault Logic – From the drop-
down lists, select Disable or Enable.
•
Reference Oscillator Adjust – Enter a value from 0-255.
LNA Parameters
•
Current Alarm Window – Enter a value of 20-50, or 99 to disable this feature.
•
Current Source – From the drop-down list, select Disable or Enable.
•
Fault Logic – From the drop-down list, select Summary or No Summary.
ODU Circuit Identification
Enter an ODU Circuit Identification name of up to 24 alphanumeric characters.
Click [Submit] to save.
ODU (Transceiver, BUC, LNB) Operation
CDM-425 Advanced Satellite Modem
10–47
Revision 0
MN-CDM-425
Advertisement
Table of Contents
