Table of Contents
Advertisement
Step
Task
6
Prepare the IP Packet Processor Card for installation by aligning
its receptacle with the mating connector on the modem's framing
board.
Plug the card firmly into the connector – take care not to damage
any top-mounted components. Similarly, be sure not to damage
the bottom of the card on the chassis' mounting bosses while
plugging the card receptacle into its mating connector.
Installation is complete once the cable connector is fully engaged
within its mating receptacle, and the mounting holes at the front
of the card are aligned with the mounting boss threaded holes.
7
Use the screwdriver to secure the IP Packet Processor card to
the chassis with its provided mounting hardware (2X 4-40 x 1/4
pan head screws).
Appendix J
J–14
CDM-425 Advanced Satellite Modem
Revision 0
MN-CDM-425
Advertisement
Table of Contents
