When you select Port (only) or VLAN&Port, the display updates to include Port Priority on the
bottom line:
L2 QoS=Port only
Port Priority: P1:1 P2:2 P3:1 P4:1 ()
Define Port Priority by using the ◄ ►arrow keys to select the port (P1, P2, P3, or P4), and then
using the ▲▼ arrow keys to designate a priority from 1 to 4 (with Priority 4 being the highest).
CONFIG: IP IP Setup: QoS L3 QoS
When the optional IP Packet Processor card is either not installed or installed but disabled, and
L3 QoS is selected, this menu is disabled and appears as follows:
L3 QoS=Off
(Fixed at Off)
Otherwise, when the optional IP Packet Processor card is installed and enabled, the L3 QoS
menu appears as follows:
L3 QoS=Off
(Off,Max/Prio,MinMax,DiffServ)
Use the ▲▼ arrow keys to set the L3 QoS operational priority. Press ENTER.
Valid settings are:
Setting
Off
Max/Prio
MinMax
DiffServ
Front Panel Operation
QoS disabled.
(Maximum priority only) Provides multi-level traffic prioritization with the ability to limit maximum
traffic per priority class.
(Minimum/Maximum priority) Provides a Committed Information Rate (CIR) to each user-defined
class of traffic with the ability to allow a higher burstable rate depending on availability.
(DiffServ priority only) Industry-standard method of providing QoS, enabling seamless co-
existence in networks that implement DiffServ.
CDM-425 Advanced Satellite Modem
(Off,VLAN,PT,VLAN&Port)
Function
6–67
Revision 0
()
()
MN-CDM-425