10.4.2.4.2.2 ODU | Config (KST-2000A/B)
Figure 10-11 shows the 'ODU | Config' page as it appears when you configure the Comtech EF
Data KST-2000A/B as the ODU. Use this page to configure the primary ODU's Transmit and
Receive Parameters.
Up Converter
•
Frequency – Enter a value in MHz.
•
Attenuation – Enter a value in dB.
•
Output – From the drop-down list, select On or Off.
Down Converter
•
Frequency – Enter a value in MHz.
•
Attenuation – Enter a value in dB.
•
Rx Band (For KST-2000B Only) – From the drop-down list, select band A (10950 to
11700 MHz), band B (11700 to 12200 MHz), or band C (12250 to 12750 MHz).
HPA
•
HPA Power Enable – From the drop-down list, select On or Off.
•
HPA Fault Logic – From the drop-down list, select Summary or No Summary.
ODU (Transceiver, BUC, LNB) Operation
Figure 10-11. ODU | Config Page (KST-2000A/B)
10–48
CDM-425 Advanced Satellite Modem
MN-CDM-425
Revision 0