Home > Remote Mode - Comtech EF Data CDM-425 Installation And Operation Manual

9.3.1 Home > Remote Mode
In order to proceed with the operations described through the remaining chapter, you must be
sure to set Remote Mode to [Ethernet] in order for configuration changes to be saved into
memory.
First, from the Home menu, press [K] to open the Remote Access Mode dialog window:
Then, use the ↑↓ arrow keys to select the Remote Mode as Ethernet, and press [ENTER] to accept the
selection. Finally, press [F8] to save to memory. Note the following:
Remote Mode Selection
Local
Serial
EDMAC Slave
Ethernet
Telnet Command Line Interface (CLI) Operation
Configuration using Front Panel only
Chapter 6. FRONT PANEL OPERATION
Configuration using Serial Port
• Sect. 6.2.1.12 CONFIG: REMOTE (Remote Control)
• Chapter 8. SERIAL-BASED REMOTE PRODUCT
MANAGEMENT
EDMAC mode cannot be set here – the CLI displays "EDMAC
Slave" when the modem is in EDMAC Slave Mode
Appendix H. EDMAC CHANNEL
Configuration using SNMP / Telnet CLI / Web Server Interface
Chapter 7. ETHERNET-BASED REMOTE PRODUCT
MANAGEMENT
9–12
CDM-425 Advanced Satellite Modem
Function
Revision 0
MN-CDM-425