Comtech EF Data CDM-425 Installation And Operation Manual page 526

ODU: FSK-control  BUC  Advanced-FSK  LPOD (2LPODs 
Online/Offline LPOD) Information  Mask
Mask: LFRFPwr=Masked ERLD=Masked
FanSpd=Alarm
This screen displays the LPOD mask settings.
ODU: FSK-control  BUC  Advanced-FSK  LPOD (2LPODs 
Online/Offline LPOD)  Information  Misc
Misc: AFR=Enabled
LowFwdPowerThreshold=00.00
This screen displays the Auto Fault Recovery state, the Internal 10MHz Reference setting, and
the Low Forward Power Threshold setting.
10.3.3.3.3.4.3.1.6 ODU: FSK-control  BUC  Advanced-FSK  LPOD (2LPODs Online/Offline LPOD)  Redun
Redundancy-Switch-Mode=1:1 Red TX+RX
Force-Online=N Online-State=Offline()
Use the ◄ ►arrow keys to select a setting, and then use the ▲▼ arrow keys to change that
setting:
Selection
Redundancy-Switch-Mode
Force-Online
Online-State
Press ENTER when done.
ODU (Transceiver, BUC, LNB) Operation
LNBCD=Alarm LNB22V=Alarm
Ref-Adjust=087
Off, 1:1 Red Tx, 1:1 Red TX+RX, Manual.
Select Yes to force Offline unit to generate a redundant switchover.
Otherwise, select No.
Read-only. Displays status as Online or Offline.
10–36
CDM-425 Advanced Satellite Modem
Setting
MN-CDM-425
Revision 0