Table of Contents
Advertisement
MEO
Feature: Use the drop-down list to select MEO as Disabled or Enabled.
Click [Submit] to save.
Once the MEO feature is enabled, you may set the Antenna Handover operating parameters.
Antenna Handover
•
Handover Type: Use the drop-down list to select Break Before Make or Make Before
Break.
•
Feature: Use the drop-down list to select Antenna Handover operation as Disabled or
Enabled.
•
Mode: Use the drop-down list to set the Antenna Handover action as Auto or Manual.
•
ACU IP Address: This read-only item displays the IP Address generated by the active
Antenna Controller Unit.
•
Communication Port: Enter a value 01001 to 65535.
•
Handover Delay: Enter a delay value.
•
Differential Path Delay: This is a read only display that shows the DPD.
Ethernet-based Remote Product Management
CDM-425 Advanced Satellite Modem
7–73
Revision 0
MN-CDM-425
Advertisement
Table of Contents
