Using The Telnet Interface For Telnet Command Line Interface (Cli) Operation - Comtech EF Data CDM-425 Installation And Operation Manual

7.4.2 Using the Telnet Interface for Telnet Command Line Interface (CLI)
Operation
1. The Telnet Command Line Interface (CLI) is accessible only when you install
and enable the optional IP Packet Processor.
2. The Telnet CLI uses Telnet TCP Port 107. Be sure to specify this port when
configuring your terminal emulator for CLI operation.
3. The HyperTerminal terminal emulator, while compatible for use with remote
control operations, is not supported or recommended for Telnet CLI
operation. Instead, for best results Comtech EF Data recommends PuTTY or
Tera Term or as the preferred terminal emulators (Figure 7-1).
Ethernet-based Remote Product Management
(LEFT) TeraTerm CLI Example
(RIGHT) PuTTY CLI Example
Figure 7-1. Telnet Command Line Interface (CLI)
7–7
CDM-425 Advanced Satellite Modem
MN-CDM-425
Revision 0