Comtech EF Data CDM-425 Installation And Operation Manual page 186

6.2.1.13.3.9 CONFIG: IP  IP Setup: Stats
IPstats: Port x
Unicasts:
This screen displays IP traffic statistics for both the In (Ingress) and Out (Egress) directions.
Use the ◄ ►arrow keys to navigate to the proper line, in this order:
On the top line – Use the ▲▼ arrow keys to select the bottom-line IP Stats Type as WAN,
Ports 1 through 4, HDLC FPGA, or Management. ("In" and "Out" are column labels for the
bottom line parameters and are not selectable.)
On the bottom line – Use the ▲▼ arrow keys to view the desired statistical parameter.
Available statistics are:
IP Stats Type
(Use ▲▼ to select)
WAN
Port 1
Port 2
Port 3
Port 4
HDLC FPGA
Management
Clear the IP Statistics accumulators by using the ◄ ►arrow keys to move the cursor to Clr:N;
then, use the ▲▼ arrow keys to select Clr:Y. Press ENTER.
Front Panel Operation
In
00000003
(Use ◄ ► to navigate to the bottom line, and then ▲▼ to display a desired statistic)
HDLC Frames In / Out
Tx Dropped
Rx CRC Error
Unicasts
Broadcasts
Pause
Multicasts
FCS Error
Align Error*
Good Octets
Bad Octets*
Undersize
Fragments*
64 Octets
127 Octets
255 Octets
CDM-425 Advanced Satellite Modem
Out ()
00000023 Clr:N
Available Statistics
511 Octets
1023 Octets
Max Octets
Jabber*
Oversize*
Discards
Filtered*
Collisions**
Multiple**
Single**
Deferred**
Late**
Excessive**
6–68
Revision 0
*Indicates In only
**Indicates Out only
MN-CDM-425