Table of Contents
Advertisement
Tightening Torque Specifications
Fastening part
Camshaft housing bolt
Camshaft housing bolt
Intake manifold bolt and nut
Cylinder head cover bolt
Engine cover bolt
Engine left mounting bolt
Engine right mounting bracket nut
Timing chain cover bolt
Crankshaft pulley bolt
Timing chain No.1 guide bolt
Timing chain tensioner bolt
Timing chain tensioner adjuster bolt
Camshaft housing bolt
Venturi plug
Cylinder head bolt for M10
Cylinder head bolt for M8
Connecting rod bearing cap nut
Sensor plate bolt
Crankshaft bearing cap No.1 bolt ((1) – (10))
Crankshaft bearing cap No.2 bolt ((11) – (20))
Rear oil seal housing bolt
Flywheel or drive plate bolt
NOTE
The specified tightening torque is also described in the following.
"Throttle Body Components"
"Throttle Body and Intake Manifold Components"
"Engine Mountings Components"
"Timing Chain Cover Components"
"Timing Chain and Chain Tensioner Components"
"Camshaft, Tappet and Shim Components"
"Valves and Cylinder Head Components"
"Pistons, Piston Rings and Connecting Rods Components"
"Main Bearings, Crankshaft and Cylinder Block Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Specifications
Tightening torque
N⋅m
kgf-m
8
0.8
11
1.1
25
2.5
Tighten 8 N⋅m (0.8 kgf-m, 6.0 lb-ft) by the
specified procedure
Tighten 8 N⋅m (0.8 kgf-m, 6.0 lb-ft) by the
specified procedure
55
5.5
75
7.5
23
2.3
150
15.0
9
0.9
22
2.2
11
1.1
Tighten 11 N⋅m (1.1 kgf-m, 8.0 lb-ft) by the
specified procedure
5
0.5
Tighten 20 N⋅m (2.0 kgf-m, 14.5 lb-ft), 40
N⋅m (4.0 kgf-m, 29.0 lb-ft), 60° and 60° by
the specified procedure
Tighten 22 N⋅m (2.2 kgf-m, 16.0 lb-ft) by the
specified procedure
Tighten 15 N⋅m (1.5 kgf-m, 11.0 lb-ft), 45°
and 45° by the specified procedure
11
1.1
Tighten 30 N⋅m (3.0 kgf-m, 22.0 lb-ft), 50
N⋅m (5.0 kgf-m, 36.5 lb-ft) and 60° by the
specified procedure
Tighten 22 N⋅m (2.2 kgf-m, 16.0 lb-ft) by the
specified procedure
11
1.1
70
7.0
Engine Mechanical:
S3RH0A1407001
Note
lb-ft
(for tightening of
6.0
special tool)
8.0
18.0
40.0
54.5
17.0
108.5
6.5
16.0
8.0
/
3.5
/
8.0
/
/
/
/
8.0
51.0
1D-56
Advertisement
Chapters
Table of Contents
