How To Configure Fx Series Installation Pattern (In-Line Mode); Cable The Appliance; Configure The Appliance - Comtech EF Data FX series 1005 Administrator's Manual

Comtech EF Data / Stampede

2.3 How to configure FX Series Installation Pattern (In-Line Mode)

2.3.1 Cable the Appliance

The eth2 (LAN) and eth3 (WAN) ports both need to be connected to a switch or router in which:
The eth2 (LAN) port is on the link closest to the back end servers if the appliance is an FX-ADC or
Clients if the appliance is a FX-Remote.
The eth3 (WAN) port is on the link closest to the satellite modem.
FX Series ADC

2.3.2 Configure the Appliance

Login to the appliance through the browser interface at:
http://{IP_address_of_the_appliance}:10000
1. Enter the default user name "comtech" and the
default password "comtech".
a. Click Login.
2. Go to Configuration -> General Settings
a. Change "Traffic interception mode" to "In-
Line".
b. Click Save.
3. Go to Traffic Interfaces -> In-Path Interfaces
a. Click the Add button to add a new in-path
interface.





b. Click "Add In-Path Interface".
FX Series Administration Guide - Version 6.2.2
Chapter: Initial Installation Information
Section: How to configure FX Series Installation Pattern (In-Line Mode)
Enter the VLAN ID of 0. If no VLAN
tagging is to be used. Use the VLAN ID
of the VLAN if traffic is to be VLAN
tagged
Enter the IP Address.
Enter the Netmask.
Enter the Gateway.
Enter any static routes needed in the
"Routes" field.
FX Series Remote
MN-FXSERIESADM6 Rev 6
52