Lldp Med Network-Policy (Interface) - Cisco 300 Series Cli Manual

37
Link Layer Discovery Protocol (LLDP) Commands
•
value
dscp —DSCP value to be used for the specified application.
Default Configuration
No network policy is defined.
Command Mode
Global Configuration mode
User Guidelines
Use the lldp med network-policy Interface Configuration command to attach a
network policy to a port.
Up to 32 network policies can be defined.
Example
This example creates a network policy for the voice-signally application and
attaches it to port 1. LLDP packets sent on port 1 will contain the information
defined in the network policy.
switchxxxxxx (config)# lldp med network-policy 1 voice-signaling vlan 1
vlan-type untagged up 1 dscp 2
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# lldp med network-policy add 1

37.18 lldp med network-policy (interface)

Use the lldp med network-policy Interface Configuration (Ethernet) mode
command to attach or remove an LLDP MED network policy on a port. Network
policies are created in lldp med network-policy (global).
Use the no form of this command to remove all the LLDP MED network policies
from the port.
Syntax
{add | remove} number
lldp med network-policy
number
no lldp med network-policy
616 78-21075-01 Command Line Interface Reference Guide