Lldp Reinit - Cisco Nexus 7000 Series Reference Manual

lldp reinit

lldp reinit
To configure the delay time for the Link Layer Discovery Protocol (LLDP) to initialize on any interface,
use the lldp reinit command. To remove the LLDP initialization configuration, use the no form of this
command.
Syntax Description seconds
Defaults
2 seconds
Command Modes Global configuration mode (config)
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(1)
Usage Guidelines Make sure that you are in the correct virtual device context (VDC). To switch VDCs, use the switchto
vdc command.
This command does not require a license.
Examples This example shows how to configure the delay time for LLDP initialization:
switch(config)# lldp reinit 6
switch(config)#
This example shows how to remove the LLDP initialization configuration:
switch(config)# no lldp reinit 6
switch(config)#
Related Commands Command
lldp holdtime
Cisco Nexus 7000 Series NX-OS System Management Command Reference
232
lldp reinit seconds
Initialize time in seconds. The range is from 1 to 10.
Modification
This command was introduced.
Description
Specifies the amount of time in seconds that a receiving device should hold
the information sent by your device before discarding it.
L Commands
OL-25806-03