Show Parser Macro - Cisco Catalyst 3750 Metro Command Reference Manual

show parser macro

show parser macro
Use the show parser macro user EXEC command to display the parameters for all configured macros
or for one macro on the switch.
Syntax Description brief
description [interface
interface-id]
name macro-name
Command Modes
User EXEC
Command History Release
12.2(25)EY
Examples
This is a partial output example from the show parser macro command. The output for the Cisco-default
macros varies depending on the switch platform and the software image running on the switch:
Switch# show parser macro
Total number of macros = 6
--------------------------------------------------------------
Macro name : cisco-global
Macro type : default global
# Enable dynamic port error recovery for link state
# failures
errdisable recovery cause link-flap
errdisable recovery interval 60
<output truncated>
--------------------------------------------------------------
Macro name : cisco-desktop
Macro type : default interface
# macro keywords $AVID
# Basic interface - Enable data VLAN only
# Recommended value for access vlan (AVID) should not be 1
switchport access vlan $AVID
switchport mode access
<output truncated>
--------------------------------------------------------------
Macro name : cisco-phone
Macro type : default interface
# Cisco IP phone + desktop template
# macro keywords $AVID $VVID
# VoIP enabled interface - Enable data VLAN
# and voice VLAN (VVID)
Catalyst 3750 Metro Switch Command Reference
2-582
show parser macro [{brief | description [interface interface-id] | name macro-name}]
(Optional) Display the name of each macro.
(Optional) Display all macro descriptions or the description of a specific
interface.
(Optional) Display information about a single macro identified by the macro
name.
Modification
This command was introduced.
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
OL-9645-10