Adding Ip Multicast Group Addresses - Cisco Small Business 200 Administration Manual

Multicast

Adding IP Multicast Group Addresses

STEP 7
STEP 8
STEP 9
STEP 10
Adding IP Multicast Group Addresses
Cisco Small Business 200 Series Smart Switch Administration Guide
To configure and display the registration for the interfaces within the group, select
an address, and click Details.
The page contains:
• VLAN ID—The VLAN ID of the Multicast group.
• MAC Group Address—The MAC address of the group.
Select the port or LAG to be displayed from the Filter: Interface Type menu.
Click Go to display the port or LAG membership.
Select the way that each interface is associated with the Multicast group:
• Static—Attaches the interface to the Multicast group as a static member.
• Dynamic—Indicates that the interface was added to the Multicast group as
a result of IGMP/MLD snooping.
• Forbidden—Specifies that this port is not allowed to join this group on this
VLAN.
• None—Specifies that the port is not currently a member of this Multicast
group on this VLAN.
Click Apply, and the Running Configuration file is updated.
Entries that were created in the IP Multicast Group Address page
NOTE
cannot be deleted in this page (even if they are selected).
The IP Multicast Group Address page is similar to the MAC Group Address page
except that Multicast groups are identified by IP addresses.
The IP Multicast Group Address page enables querying and adding IP Multicast
groups.
15
212