Bridge Multicast Ipv6 Source Group - Cisco Sx350 Cli Manual

4
139
•
add—(Optional) Forbids adding ports to the group.
•
remove—(Optional) Forbids removing ports from the group.
•
interface-list
ethernet
Separate nonconsecutive Ethernet ports with a comma and no spaces. Use
a hyphen to designate a range of ports.
•
port-channel-list
port-channel
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers an IPv6 Multicast address, and forbids the IPv6
address on port gi14 within VLAN 8.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
FF00:0:0:0:4:4:4:1 add gi14

4.12 bridge multicast ipv6 source group

To register a source IPv6 address - Multicast IPv6 address pair to the bridge table,
and statically add or remove ports to or from the source-group, use the bridge
—(Optional) Specifies a list of Ethernet ports.
—(Optional) Specifies a list of port channels.
interface vlan 8
bridge multicast ipv6 ip-address FF00:0:0:0:4:4:4:1
bridge multicast ipv6 forbidden ip-address
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Address Table Commands