Enabling Cfs Over Ipv6; Verifying The Cfs Over Ip Configuration; Configuring Ip Multicast Address For Cfs Over Ip - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Enabling CFS over IPv6

Procedure
Step 1
Step 2
Step 3
Enabling CFS over IPv6
You can enable or disable CFS over IPv6.
CFS cannot distribute over both IPv4 and IPv6 from the same switch.
Note
Procedure
Step 1
Step 2
Step 3

Verifying the CFS Over IP Configuration

To verify the CFS over IP configuration, use the show cfs status command.
switch# show cfs status
Distribution : Enabled
Distribution over IP : Enabled - mode IPv4
IPv4 multicast address : 239.255.70.83
IPv6 multicast address : ff15::efff:4653

Configuring IP Multicast Address for CFS over IP

All CFS over IP enabled switches with similar multicast addresses form one CFS over IP network. CFS
protocol-specific distributions, such as the keepalive mechanism for detecting network topology changes, use
the IP multicast address to send and receive information.
Note CFS distributions for application data use directed unicast.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
310
Command or Action
switch# configure
switch(config)# cfs ipv4 distribute
switch(config)# no cfs ipv4 distribute
Command or Action
switch# configure
switch(config)# cfs ipv6 distribute
switch(config)# no cfs ipv6 distribute
Using Cisco Fabric Services
Purpose
Enters configuration mode.
Globally enables CFS over IPv6 for all
applications on the switch.
(Optional)
Disables (default) CFS over IPv6 on the switch.
Purpose
Enters configuration mode.
Globally enables CFS over IPv6 for all
applications on the switch.
(Optional)
Disables (default) CFS over IPv6 on the switch.
OL-16597-01