Setting Procedure For Monitoring Other Stations - Mitsubishi Electric GOT2000 Series User Manual

(2) Key functions
The following shows the functions of the keys that are used for the operations on the system configuration screen.
1) Motion controller CPU status display
Select the motion controller CPU (MELSEC iQ-R series) where servo monitor/servo parameter setting is
performed.
2) [ChNET PCNo] key
Displays the communication setting window.
3) [END] key
Exits the monitor and returns to the screen where the R motion monitor was started.
4) [Motion Monitor] key
Changes the System Configuration screen to the monitor menu screen.
➠
5) [Parameter Set.] key
Changes the System Configuration screen to the parameter setting screen.
➠
6) Scroll key
Scrolls the display one stage up or down to display the system configuration of the currently undisplayed stage
immediately before/after the currently displayed stage.
16.4.2

Setting procedure for monitoring other stations

The following shows the setting procedure for monitoring other stations with R motion monitor.
Step 1.
In the communication setting window, select one from channel No.1 to 4.
For the operations of the communication setting screen, refer to the following.
➠
16 - 8
16.4 Operation Procedures
1)
5)
4)
16.4.3 Monitor menu screen
16.4.10 Parameter setting screen
■1. Communication setting window
2) 3)
6)
6)