Mitsubishi Electric GOT2000 Series User Manual page 349

(3) High Performance model QCPU
Item
Parameter
Intelligent function module
*3
parameter
Program
Device comment
Boot operation specification file
Device initial value
*1*4
File register
*2
Sampling trace file
*2
Failure history data
Programmable controller user data
*1 The file register in the Flash card installed in the CPU is always restored without confirming saving.
Whether the file register in the SRAM card or standard RAM is restored or not can be selected in a dialog displayed at restoration.
When the file register is not restored, the existing file register is deleted.
Therefore, programs of the controller may not work normally.
If a problem occurs in the operation of the controller after restoration, perform the restoration again, including to the file register.
*2 The item can be backed up only.
*3 The target is only parameters of the intelligent function modules controlled by the CPU module.
The parameters stored in the intelligent function module are not included.
*4 Whether to retain the file register of a PLC at restoration is selectable.
➠
10.3.1 Setting storage location for backup data
(4) Universal model QCPU
Item
Parameter
Intelligent function module
*3
parameter
Program
Device comment
Boot operation specification file
Device initial value
*1*4
File register
*2
Sampling trace file
Programmable controller user data
File for storing device data
Drive heading
Remote password
Monitor sequence extension
Latch data backup file
*1 The file register in the Flash card installed in the CPU is always restored without confirming saving.
Whether to restore the file register stored in the SRAM card or standard RAM is selectable in a dialog appearing at restoration.
When the file register is not restored, the existing file register is deleted.
Therefore, programs of the controller may not work normally.
If a problem occurs in the operation of the controller after restoration, perform the restoration again, including to the file register.
*2 The item can be backed up only.
*3 The target is only parameters of the intelligent function modules controlled by the CPU module.
The parameters stored in the intelligent function module are not included.
*4 Whether to retain the file register of a PLC at restoration is selectable.
➠
10.3.1 Setting storage location for backup data
Description
Parameter for operating a programmable controller
Parameter for intelligent function modules
Program that the CPU operates (Including SFC program)
Device comment to be stored in a programmable controller
Batch file for starting programs stored in ROM and others
Setting the device initial value
Data stored in file registers
Sampling trace data that the specified device data is
continuously collected with the specified timing
Failure history data that are recorded self-diagnostic results
Any user-created data stored in a memory card
Description
Parameter for operating a programmable controller
Parameter for intelligent function modules
Program that the CPU operates (Including SFC program)
Device comment to be stored in a programmable controller
Batch file for starting programs stored in ROM and others
Setting the device initial value
Data stored in file registers
Sampling trace data that the specified device data is
continuously collected with the specified timing
Any user-created data stored in a memory card
Device data used for the SP.DEVST and S.DEVLD instructions
The heading of the drive
Remote password settings
Data to increase the speed of monitors from other stations.
Stores the backup data for the latch data backup function to the
standard ROM.
File name
PARAM.QPA
IPARAM.QPA
***.QPG
***.QCD
AUTOEXEC.QBT
***.QDI
***.QDR
***.QTD
***.QFD
***.*** (Optional)
File name
PARAM.QPA
IPARAM.QPA
***.QPG
***.QCD
AUTOEXEC.QBT
***.QDI
***.QDR
***.QTD
***.*** (Optional)
DEVSTORE.QST
QN.DAT
00000000.QTM
MONITOR.Q0*
LCHDAT00.QBK
10.2 Specifications
10
10 - 7