Operations For Display - Mitsubishi Electric GOT2000 Series User Manual

16.3 Operations for Display

This section explains how to display the R motion monitor screen after the GOT is turned on.
Step 1.
Turn on the power to the GOT.
Step 2.
Display the R motion monitor screen.
Use either of the following display methods.
• Starting from the special function switch (R motion monitor) set in the project
For how to set special function switches, refer to the following.
➠
• Starting from the utility
After the utility is displayed, touch [Monitor] → [R Motion monitor] from the Main Menu.
For how to display the utility, refer to the following.
➠
Step 3.
Set the channel number.
Set the channel number of the controller for which the R motion monitor is performed.
After the GOT is powered on, the communication setting window is displayed automatically only at the first
startup of the R motion monitor.
To display the communication setting window after the first startup, touch the [ChNET PCNo] key on the R
motion monitor screen.
➠
Step 4.
Start the R motion monitor.
The System Configuration screen is displayed after the channel number is selected.
Touch a motion controller CPU (MELSEC iQ-R series) to monitor.
Touching the [Parameter Set.] key displays the parameter setting screen.
Touching the [Motion Monitor] key displays the monitor menu.
16 - 4
16.3 Operations for Display
GT Designer3 (GOT2000) Screen Design Manual
GOT2000 Series User's Manual (Utility)
16.4 Operation Procedures
Communication setting window