Mitsubishi Electric GOT2000 Series User Manual page 350

(5) LCPU
Item
Parameter
Intelligent function module
*3
parameter
Program
Device comment
Boot operation specification file
Device initial value
*1*4
File register
Sampling trace file
Programmable controller user data
File for storing device data
Drive heading
Remote password
Monitor sequence extension
Latch data backup file
Data logging setting file
Menu definition file
*1
*2 The item can be backed up only.
*3
*4
(6) MELSERVO-J4 series
Item
Parameter
Point table
10 - 8
10.2 Specifications
Parameter for operating a programmable controller
Parameter for intelligent function modules
Program that the CPU operates (Including SFC program)
Device comment to be stored in a programmable controller
Batch file for starting programs stored in ROM and others
Setting the device initial value
Data stored in file registers
Sampling trace data that the specified device data is
*2
continuously collected with the specified timing
Any user-created data stored in a memory card
Device data used for the SP.DEVST and S.DEVLD
instructions
The heading of the drive
Remote password settings
Data to increase the speed of monitors from other stations.
Stores the backup data for the latch data backup function to
the standard ROM.
Setting the data logging
Menu defining files
The file register in the Flash card installed in the CPU is always restored without confirming saving.
Whether the file register in the SRAM card or standard RAM is restored or not can be selected in a dialog displayed at restoration.
When the file register is not restored, the existing file register is deleted.
Therefore, programs of the controller may not work normally.
If a problem occurs in the operation of the controller after restoration, perform the restoration again, including to the file register.
The target is only parameters of the intelligent function modules controlled by the CPU module.
The parameters stored in the intelligent function module are not included.
Whether to retain the file register of a PLC at restoration is selectable.
➠
10.3.1 Setting storage location for backup data
Parameter for operating a servo amplifier
Point table data
Description
Description
File name
PARAM.QPA
IPARAM.QPA
***.QPG
***.QCD
AUTOEXEC.QBT
***.QDI
***.QDR
***.QTD
***.*** (Optional)
DEVSTORE.QST
QN.DAT
00000000.QTM
MONITOR.Q0*
LCHDAT00.QBK
LOGCOM.QLG
LOG01.QLG to
LOG10.QLG
MENUDEF.QDF
File name
***.CP1
***.PTB2