Setting Procedure For The Ip Filter - Mitsubishi Electric GOT SIMPLE Series User Manual

Setting procedure for the IP filter

Setting the IP filter
1.
Select [Yes] for [IP filter usage] by touching the current selection.
2.
Select [Transmit] or [Block] for [Transmit/Block] by touching the current selection.
3.
Touch the [Setting] button of [IP address setting] to display the [IP address setting] screen.
Refer to the following, and set an IP address.
Page 124 Adding a target IP address
Page 125 Deleting a target IP address
Page 126 Specifying IP address ranges
Page 127 Setting exception IP addresses
4.
After configuring the settings, touch the [×] button to display the [IP filter setting] screen.
5.
Touch the [×] button to display the following screen.
6.
Touch the [YES] button to restart the GOT and reflect the setting.
To cancel the new settings, touch the [NO] button to return to the [GOT setup] screen.
1.
2.
3.
4. 1.
12 DISPLAY AND OPERATION SETTINGS (GOT SET UP)
123
12.7 IP Filter Setting
12