Setting Motion Sfc Program Storage Location - Mitsubishi Electric GOT2000 Series User Manual

Graphic operation terminal

Hide thumbs Also See for GOT2000 Series:

Table of Contents

Setting motion SFC program storage location

The motion SFC program read from a motion controller CPU and the ladder data for the sequence program monitor

(Ladder) are stored in the same destination.

Only drive A (standard SD card) or drive B (USB drive) is usable for storing motion SFC programs.

For the ladder data storage destination setting, refer to the following.

• When setting with GOT utility

• When setting with GT Designer3(GOT2000)

14.3 Operations for Display

GOT2000 Series User's Manual (Utility)

GT Designer3 (GOT2000) Screen Design Manual