Parameter Setting Screen - Mitsubishi Electric GOT2000 Series User Manual

7.4.11

Parameter setting screen

This section describes the structure of the screen and the common operations when you configure the parameter setting.
■1. Display contents and key functions
You can set the servo parameters (basic parameters/adjustment parameters) of the connected motion controller CPU.
This section describes the display data of the parameter setting screen and the key functions displayed on the screen.
(1) Displayed screen
1) Parameter setting screen
Displays the servo parameter of the selected item.
(2) Key functions
1) [AxNo.] key
Changes the axis whose parameter setting will be made.
2) [Sys. Conf] key
Returns to the System Configuration screen.
3) [END] key
Exits the parameter setting and returns to the screen where the Q motion monitor was started.
4) Item selection key
Selects the servo parameter setting item.
5) [CHG] key
Changes the servo parameter setting of the selected item.
7 - 26
7.4 Operation Procedures
1)
4)
6) 7)
1) 2) 3)
5)