Mitsubishi Electric GOT2000 Series User Manual page 362

(3) Keyword for restoring data
When data are restored to a target FXCPU, a keyword in the FXCPU is held.
For setting or disabling a keyword for the FXCPU, refer to the following manual.
➠
(4) Backup data which contains source information
When the target FXCPU of the restoration does not support source information, the backup data which contains
source information cannot be restored.
■9. Precautions for using the CNC C70
(1) Handling backup data
Although some backup data can be checked with a text editor, do not change the contents.
If the contents are changed, the data cannot be restored.
(2) Individual restoration of the C language module
The C language module cannot be restored on the individual restoration screen of the GOT.
To restore the C language module individually, use Remote Monitor Tool whose version is C0 or later.
For Remote Monitor Tool, refer to the following.
➠
■10. Precautions for using the CNC C80
(1) Handling backup data
Although some backup data can be checked with a text editor, do not change the contents.
If the contents are changed, the data cannot be restored.
■11. Precautions for robot controller
(1) Restoration during program execution
The restoration cannot be performed during program execution.
(2) Confirmation before restoring
• Confirm the error cause in advance, since the error record is deleted by restoring.
• Confirm that the error C7500 "No battery voltage" does not occur when restoring.
(3) Restoration when replacing a robot
If models of robots are different, the restoration cannot be performed.
If a robot, motor, reducer, or belt is replaced, configure the origin setting.
If a robot controller is compatible with the maintenance forecast, reset the maintenance forecast when replacing the
robot or belt.
(4) Operations during backing up or restoration on the GOT
Do not execute [Program read], [Program save], [Backup/Restore] or others for robot controllers to be backed up or
restored from RT ToolBox2 or R56TB, while backing up or restoring on the GOT.
Doing so causes lack of consistency of data in a robot controller or acquired from RT ToolBox2.
(5) Version of the robot controller
The backed up data of the robot controller version R1d/S1d or later cannot be restored in the robot controller version
R1c/S1c or earlier.
(6) Edit and restoration of backup data
The data backed up on the GOT can be edited and restored with RT ToolBox2.
To edit and restore data with RT ToolBox2, copy the data backed up on the GOT to the Backup folder in the project
folder in RT ToolBox2.
However, the following data cannot be restored on the GOT.
• Data edited with RT ToolBox2 after the backup on the GOT.
• Data backed up with RT ToolBox2 or R56TB.
10 - 20
10.2 Specifications
GOT2000 Series User's Manual (Utility)
Programming manual for the FXCPU used
MITSUBISHI CNC C70 / C64 Series Remote monitor tool Operating Manual