Operations For Display - Mitsubishi Electric GOT2000 Series User Manual

12.3 Operations for Display

This section describes how to display the log viewer screen after the GOT is turned on.
Starting from
the utility
*1
Display the utility.
After the utility is displayed, touch
[Monitor] → [Log viewer] from the Main
Menu.
When no password is registered for
the target controller at first start-up,
or [Offline (view file)] is selected
The main menu of log viewer
is displayed.
For [View logged device]
[Log viewer] screen is displayed.
*1 For how to display the utility, refer to the following.
➠
*2 For how to set special function switches, refer to the following.
➠
*3 For the details, refer to the following.
➠
*4 For the details, refer to the following.
➠
*5 For the details, refer to the following.
➠
*6 For the details, refer to the following.
➠
*7 For the details, refer to the following.
➠
Turn on the power to the GOT
Touch the special function switch.
Refer to the following manual for how
to set the special function switch.
*5
*6
End
GOT2000 Series User's Manual (Utility)
GT Designer3 (GOT2000) Screen Design Manual
11.4 Operation Procedures
12.4.2 How to operate target selection screen
12.4.3 How to operate Main Menu screen
12.5.1 Data log viewer screen
12.4.4 How to operate file selection screen
Start
Starting from the special function
switch (Log viewer) set in the
project data
*2
Activate [Log viewer] on the MELSEC-L
troubleshooting screen.
Input the password.
[Select files] screen is displayed.
12.3 Operations for Display
Starting from
the MELSEC-L
troubleshooting
*3
Touch
[Log viewer].
When logging data saved in
the programmable controller
is displayed, and a password
*4
is registered for the target
controller
For [Manage log file]
*7
12
12 - 7