Error Messages And Corrective Action - Mitsubishi Electric GOT2000 Series User Manual

■2. Key functions
The following shows the functions of the keys that are used for the operations on the monitor screen.
1) [Sys. Conf.] key
Closes the current monitor and returns to the System Configuration screen.
2) [END] key
Closes the monitoring and returns the screen to the one for starting the intelligent module monitor.
3) [X/Y] key
Switches between the display contents (for an input module and for an output module) when an I/O combined
module is used.
8.7

Error Messages and Corrective Action

This section describes the error messages displayed when the intelligent module monitor is executed, and corrective action.
Error message
Communication channel setup error
Communications error
Monitor Data Can Not Find
This PLC type is not supported
Description
There is no channel for communication.
Communication could not be established with the
PLC CPU.
The special data (intelligent module monitor data)
has not been downloaded to the GOT.
The intelligent module monitor selected an
unsupported PLC CPU.
8.7 Error Messages and Corrective Action
1) 2)
3)
Corrective action
The intelligent module monitor does not support
the selected PLC CPU.
Check the connection status between the PLC
CPU and the GOT (disconnected or cut cables).
Check if an error has occurred in the PLC CPU.
Write the special data (intelligent module monitor
data) to the GOT.
Use the PLC CPU supported by the intelligent
module monitor.
➠
8.2.1 System configuration
8
8 - 37