Mitsubishi Electric GOT2000 Series User Manual page 139

Step 3.
The Factor search window is closed and the Ladder registration monitor window is displayed.
The sequence programs displayed on the ladder monitor screen are searched. Then, the factor ladder
blocks for the set device are registered in order.
The ladder blocks newly registered are always displayed in the Ladder monitor window during the factor
search.
The factor devices are highlighted.
For the Ladder registration monitor window, refer to the following.
➠ 4.6.3 ■3. Display menu (1) Ladder registration monitor window
Step 4.
The message [Factor search is completed.] is displayed in the message area when the search is
completed.
When closing the Ladder registration monitor window, the factor search mode is released.
POINT POINT POINT
Cancellation of the factor search
(1) When there are multiple factor contacts
The message [Factor search was aborted because there were multiple factor contact points.]
is displayed in the message area on the ladder monitor screen.
When continuing the factor search based on the interrupted result, execute the factor search
based on one of the found contacts.
(2) When the ladder blocks registered in the Ladder registration monitor window exceed
100
The message [Factor search was aborted because the number of ladder blocks exceeded
100.] is displayed in the message area on the ladder monitor screen.
When restarting the factor search, proceed the factor search based on the contact of the
100th ladder block.
4.8 Find/Replace Operation
4
4 - 51