Table of Contents
Advertisement
12. OPERATION OF EACH SPECIAL MODULE MONITOR SCREEN
12.1.3 Setting method for remote station monitoring
<Special Module Monitor>
When connected to MELSECNET
The setting method to perform remote station monitoring during special module
monitoring is described below.
1)
2)
In the case of data link systems
NETWK NO. :
0
STATION
:
FF (Host)
:
0 (Master station)
: 1 to 64 (Local station)
When the setting is finished, the system configuration of the specified station is
displayed.
See Sec. 12.1.4 for operations which come after these operations.
Touch SP.UNIT to display the system configuration screen.
Depending on the connection method, the screen first
displayed will be different as indicated below.
Bus connection and CPU direct
connection
MELSECNET (II), /B connection
MELSECNET/10 connection
for MELSECNET connections, the following operations will always be
required:
NETPCNo.
1) Touch
to display the window shown in 2)
Alphanumeric
2) Touch
No..
Alphanumeric
.. Enter the network No. and PLC station No..
................. Select the input area.
............. Set the area value.
12 - 3
The base of the connection station
is displayed.
No system configuration display
No system configuration display
to specify the network No. and PLC station
In the case of network systems
NETWK NO. :
0 (Host loop)
: 1 to 255 (Specified loop)
STATION
:
FF (Host)
:
0 (Station number
:
1 to 64 (Normal station)
GOT
MELSEC
of management
station)
Advertisement
Table of Contents
