Displaying The Monitor Screen - Mitsubishi Electric GOT2000 Series User Manual

3.3.1

Displaying the monitor screen

This section describes the flow until the device monitor screen is displayed after the device monitor (system application
(Extended function)) is installed in the GOT.
The display method of the device monitor screen differs between for the first time and later.
■1. Displaying the device monitor screen for the first time
Follow the procedure described below to display the device monitor screen.
Step 1.
Start the device monitor.
The following two methods are provided for starting the device monitor.
• Using the special function switch (device monitor) set for the project
Touch the special function switch (device monitor) placed on the monitor screen.
For the setting method of the special function switch, refer to the following.
➠
GT Designer3 (GOT2000) Screen Design Manual
If the project has not been written into the GOT yet, start the device monitor from the Utility.
• Starting the device monitor from the utility
Display the utility screen and select the [Monitor] tab and [Device monitor].
For the display method of the utility, refer to the following.
➠ GOT2000 Series User's Manual (Utility)
Step 2.
The communication setting window appears.
Select the connection destination and communication driver of the controller to be monitored.
➠ 3.3.4 ■2. Communication setting dialog
Step 3.
The [Device monitor] window appears.
3.3 Operations Common to the Monitor Screens
3
3 - 15