Error Messages And Corrective Actions - Mitsubishi Electric GOT2000 Series User Manual

20.5 Error Messages and Corrective Actions

This section describes the error messages displayed when the CNC monitor 2 is executed, and the corrective actions.
Message
Unable to move to the designated screen.
Unable to move to the designated system.
The Ethernet settings of the monitoring target CNC are
not correct.
Unable to do drawing. Use the latest OS.
Communication error
The screen was not switched to the specified screen.
The CNC C80 does not have the specified screen, or the specified screen No. may be incorrect.
Correct the settings of the special function switch.
For information on how to set a special function switch, refer to the following.
➠
GT Designer3 (GOT2000) Screen Design Manual
The system was not switched to the specified system.
The CNC C80 may not have the specified system.
Correct the settings of the special function switch.
When this error and the screen switching error occur at the same time, the error message of this
error is not displayed.
For information on how to set a special function switch, refer to the following.
➠
GT Designer3 (GOT2000) Screen Design Manual
The specified connection destination setting does not exist.
Correct the Ethernet setting of the GOT.
The monitor screen cannot be displayed because the OS version of the CNC C80 is not compatible
with the version of the CNC monitor 2.
Install the latest OS on the CNC C80.
The GOT is under one of the following conditions.
• The GOT cannot be connected with the CNC C80.
• The GOT is connected with the CNC C80, but the communication between them becomes
disabled.
Check the connection setting of the GOT, and check that the connection cable is connected
correctly.
When the communication with the CNC C80 is recovered, a message saying [Connection
complete] appears on the screen.
20.5 Error Messages and Corrective Actions
Description
20
20 - 11