Table of Contents
Advertisement
7.2.4
Precautions and Procedures when replacing the SYS board
A procedure for SYS board replacement is shown below.
[A] Replace DIMM and SRAM boards
Note:
Before replacing the SYS board, perform the following procedure.
P.7-15 "7.2.1 Precautions when replacing PC boards"
(1)
Confirm that the power is turned OFF.
(2)
Replace the SYS board.
(3)
Install DIMM (main memory, page memory) to the new SYS board (from the old SYS board).
(4)
Install SRAM board to the new SYS board (from the old SYS board).
[B] Update system ROM version
Update the version of system ROMs (OS data, UI data, System Firmware) with the USB media.
* See "8.1Firmware Updating with USB Media" for details.
[C] Check ROM versions
•
System firmware ROM version (08-900)
•
FROM basic section software version (08-920)
•
System firmware internal program version (08-921)
•
Version of UI data in FROM displayed at power ON (08-930)
[D] Reinstall options
When any of the options below was installed, reinstall a license for the corresponding option following
its unpacking instructions.
•
Meta Scan Enabler (GS-1010)
•
External Interface Enabler (GS-1020)
•
IPSec Enabler (GP-1080)
When GP-1070 (Data Overwrite Enabler) has been installed, "F200" service call occurs.
In this case, perform cancelling the "F200" service call (installing the OS / HDD SYS / PFC Firmware /
Engine MainFirmware / Scanner Firmware using the USB media), and then install GP-1070 (Data
Overwrite Enabler) again.
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Start
[A] Replace DIMM and SRAM board
[B] Update system ROM version
[C] Check ROM versions
[D] Reinstall options
Setting completed
Fig. 7-38
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
7 - 23
REPLACEMENT OF PC BOARDS/HDD
7
Advertisement
Table of Contents
