Adding The Trunks - Avaya MCC1 Installation And Upgrades

Install and Administer Trunks
Install CAMA/E911 Trunk
1
Insert the TN429C or later CO trunk circuit pack in any available port slot. Be sure the TN744D
Call Classifier - Detector circuit pack is Vintage 2 or later.
2
Wire the CAMA trunk to the MDF (the trunk from the CO). Refer to the pinouts in
and Auxiliary Equipment Leads (Pinout Charts)
lines, 8, 16, and 24 ports; hybrid line; MET line; AUX and CO trunk or
Auxiliary Equipment Leads (Pinout Charts)
tie and DS1 tie trunk, 2- and 4-wire ISDN-BRI lines, packet data line, and 4 port DIOD.

Adding the Trunks

Return to Task List
1
At the prompt, type
2
On the Trunk Group screen
Group Type: field, enter cama.
3
In the Group Name: field, enter the desired name.
4
In the TAC: field, enter the desired trunk access code.
5
In the Outgoing Display: field, enter y.
6
In the CESID I Digits Sent: field, enter the number directed by the Central Office (CO) or
the Public Safety Answering Point (PSAP).
7
Scroll to
8
On the Administrable Timers screen (page 3), you may need to adjust these fields according to
your CO. Scroll to
9
On the Group Member Assignments screen, in the Port field, add the trunk members and press
Enter when finished.
Figure 263: CAMA Trunk Group form (page 1)
Group Number: 1
Group Name:
Direction: outgoing
ESID I Digits Sent: 0
TRUNK PARAMETERS
Trunk Type: wink-start
Outgoing Dial Type: r1mf
Trunk Termination: rc
660
add trunk next and press Enter.
Figure 263, CAMA Trunk Group form (page 1),
Figure 264, Administrable Timers form (page 3),
Figure 265, Group Member Assignments form (page 5),
TRUNK GROUP
Group Type: cama
cama Trunk Group - E911
Outgoing Display? y CESID I Digits Sent: 0
Busy Threshold: 99
Busy Threshold: 99
on page 771 for 2- and 4-wire analog and digital
on page 774 for 3-wire CO trunk, DID/DIOD trunk,
on page 661.
CDR Reports: y
COR: 1 TN: 1
SI Installation and Upgrades
Circuit Pack
Circuit Pack and
on page 660, in the
on page 661.
Page 1 of 11
TAC: 701
June 2004