New Simplex And Upgraded G3R Only; New Or Upgraded G3Si Only - Avaya MCC1 Installation And Upgrades

5
Type
reset system 4
Wait until the system has completely reset before continuing.
6
Type
change cabinet 1
In the Carrier Type column change the "B" carrier to processor and submit the form.
7
Type
change system-parameters duplication
Set the Enable Operation of SPE Duplication field to y and submit the form.
8
Type save translation
After the translations have been copied (about 10 minutes), the system returns an error code,
which must be a zero; otherwise, the translations are not copied.
9
Type reset system 3 preserve-license
License File has been saved in translations) and press Enter.

New simplex and upgraded G3r only

1
Type save translation
After the translations have been copied (about 10 minutes), the system returns an error code,
which must be a zero; otherwise, the translations are not copied.
2
Type reset system 3
Wait until the system has completely reset before continuing.
3
If the system has IP endpoints registered, unplug the Ethernet cable from the TN799 (C-LAN)
circuit pack.
This disconnects (unregisters) all IP endpoints.
4
Type set time
Ensure that the system date and time are set correctly.
5
Use one of these installation methods:
— Direct connection between the switch and RFA
— No connection between the switch and RFA

New or upgraded G3si only

1
Retrieve the RFA License File with both serial numbers from the RFA Application.
2
If the system has IP endpoints registered, unplug the Ethernet cable from the TN799 (C-LAN)
circuit pack.
This disconnects (unregisters) all IP endpoints.
3
Type
set time
Ensure that the system date and time are set correctly.
4
For duplicated systems only type
Ensure that the standby SPE is not in the maintenance state. If it is, wait for the maintenance state
to finish.
5
Use one of these installation methods:
— Direct connection between the switch and RFA
— No connection between the switch and RFA
SI Installation and Upgrades
June 2004
and press Enter.
and press Enter.
and press Enter.
(or
and press Enter.
and press Enter.
and press Enter.
and press Enter.
status system all
Install Additional Hardware
Task List: Add Packet Bus Support
and press Enter.
reset system 3 no-preserve-license
and press Enter.
, since the
591