Add A Tn2501Ap Announcement Circuit Pack - Avaya MCC1 Installation And Upgrades

Install Additional Hardware

Add a TN2501AP Announcement Circuit Pack

Add a TN2501AP Announcement Circuit Pack
Return to Task List
NOTE:
To install a TN2501AP, you must ensure the system is enabled for TN2510AP (VAL)
boards. If the Maximum VAL boards field on the Customer Options screen is set to 0,
then you need to obtain and install a new license file before you can install the card.
Installing the pack includes:
1
Verifying the required hardware
2
Installing the TN2501AP circuit pack
3
Configuring the system for the TN2501AP
Verifying the required hardware
Ensure that you have the required hardware:
•
TN2501AP circuit pack
•
Backplane adapter
•
LAN cable
Installing the TN2501AP circuit pack
!
To prevent electrostatic discharge (ESD), be sure to wear a grounding strap while handling
the circuit pack.
1
Remove connector (if any) from the back of the switch cabinet corresponding to the TN2501AP
circuit pack slot.
2
Insert the circuit pack into any port slot and close the latch securely.
At first, both the red and green LEDs are on steady, then the green LED flashes. If there are
announcements on the circuit pack, the amber LED flashes while the announcements are copied
from FLASH to RAM. After approximately 3-5 minutes, all of the top 3 LEDs go out, although
this time is longer if there are announcements already recorded on the circuit pack.
NOTE:
If the TN2501AP or TN750C circuit packs are at the system limit and you insert a VAL
circuit pack, the red LED on that circuit pack stays on, indicating that the system does not
accept it.
3
Connect the Backplane Adapter to the Amphenol connector on the back of the switch cabinet,
corresponding to the TN2501AP circuit pack slot.
4
Connect the LAN cable to the RJ-45 connector on the Backplane Adapter.
578
on page 578
WARNING:
on page 578
on page 579
SI Installation and Upgrades
June 2004