TN2501AP Announcement Circuit Pack
The TN2501AP integrated announcement circuit pack
•
offers up to 1 hour of announcement storage capacity.
•
requires shorter backup and restore times.
•
is firmware downloadable.
•
plays announcements over the TDM bus, similar to the TN750C.
•
has 33 ports, including
— 1 dedicated telephone port for recording and playing back announcements (port number
1).
— 1 ethernet port (port number 33).
— 31 playback ports (ports 2–32).
•
10/100 Mb ethernet interface, allowing announcement and firmware file portability over your
LAN (FTP server functions).
•
supports .wav announcement files (see
•
works in r, si, csi, DEFINITY ONE, and Avaya IP600 models.
Important File Specifications
Voice Announcement over LAN (VAL) requires that announcement files are in the following .wav
formats:
•
CCITT A-Law or CCITT -Law companding format (do not use PCM)
•
8KHz sample rate
•
8-bit resolution (bits per sample)
•
Mono (channels = 1)
You must convert other wave ( .wav) file formats to those listed above. Telephone access creates the
correct file formats.
Save and Restore Recorded Announcements
CAUTION:
If the yellow LED is on, do not remove the circuit pack. This will corrupt the
announcement data.
The syntax for saving from any TN750 circuit pack is
Enter. Where P is the port network number (1 for PPN, and 2-4 for EPN), C is the carrier designation (A,
B, C, D, or E), and SS is the number of the slot in which the circuit pack resides (01 to 21).
SI Installation and Upgrades
June 2004
Important File Specifications
save announcements
Install Additional Hardware
Add Multiple Announcement
on page 581).
[
] and press
from PCSS
581