Administration; Place Test Call - Avaya MCC1 Installation And Upgrades

Adjuncts and Peripherals
Multimedia call handling (MMCH)

Administration

1
Enter list configuration all , and a list of the installed carriers, circuit packs, and ports appears.
2
Record the location (board number) of the new circuit packs and verify that all other required
circuit packs (refer to
3
Enter add DS1 xxxxx , (where xxxxx is the location of the TN2207 PRI circuit pack recorded in
step 2), and the DS1 circuit pack administration form appears.
4
Set the Name: field to ESM DS1
5
Set the Bit Rate: field to 2.048
6
Set the Line Coding: field to hdb3
7
Set the Signaling Mode: field to isdn-pri
8
Set the Connect: field to pbx
9
Set the Interface: field to network
10
Set the Country Protocol:
11
Set the Protocol Version: field to a
12
Set the CRC?: field to y
13
The Idle Code default is 11111111.
14
The DCP/Analog Bearer Capability default is 3.1 kHz.
15
Set the MMI Cabling Board: field to xxxxx (where xxxxx is the location of the
TN787F/H/J/K MMI circuit pack recorded in step 2). This must be the slot for port B of the Y-
cable.
16
The MMI Interface: field ESM appears.
17
Enter add signaling-group next and the signaling-group form appears.
18
Change Associated Signaling: field to y
19
Change Primary D-Channel Port: field to xxxx17 (where xxxx is the address of the
TN2207 PRI circuit pack, for example: 1B0517).
20
The Max Number of NCA TSC: default is
21
The Max Number of GA TSC: default is
22
Trunk Group for NCA TSC: ____ (leave blank)
23
Trunk Group for Channel Selection:____ (leave blank)
24
Logoff the terminal and then log back on the terminal to view your changes.

Place test call

Place multimedia data-conference call to an endpoint with known video capability to test the esm
function.
814
ESM installation) are present.
to 1
field
0.
0.
.
SI Installation and Upgrades
June 2004