Avaya MCC1 Installation And Upgrades page 364

Install and Connect SCC1 (Single-Carrier Cabinets)
Task List: Install and Connect Single-Carrier Cabinets (SCC1)
12
Install Rear Ground Plates (Systems with Earthquake Protection)
Ground Plates (Systems with Radiation Shielding and Earthquake Protection)
Install Cabinet Clips (Systems without Earthquake Protection)
13
Connect System Cables
Check Customer's Order
Return to Task List
1
Check the customer's order and the shipping packing lists to confirm all equipment is present.
2
Check the system adjuncts for damage and report all damage according to local shipping
instructions.
3
If any equipment is missing, report the information to your Avaya representative.
Unpack and Inspect Cabinets
Return to Task List
CAUTION:
Lifting the cabinet may require two people, as it may weigh as much as 130 pounds (60
kilograms). Use caution to avoid injury.
1
Unpack the cabinets from the shipping material and inspect for damage.
2
Open and remove the front door and rear panels from the cabinet.
3
Verify the label near the circuit breaker on the power supply toward the rear of each cabinet
corresponds to the local voltage type.
!
DANGER:
If the label is different than the voltage type at the site, notify your Avaya
representative immediately for a replacement power supply. Do not, under any
circumstances, connect an incorrect power supply or power source.
Return to Task List
Check Circuit Packs
Return to Task List
1
Ensure all circuit packs are fully inserted into the proper slots according to the Customer Service
Document (CSD).
Report any discrepancies in circuit pack type or quantity to your Avaya representative. For
detailed circuit pack descriptions, refer to the Hardware Guide for Avaya Communication
Manager (555-245-207).
2
Check the system adjuncts for damage and report all damage according to local shipping
instructions.
364
on page 396
on page 391 or Install Front
on page 393 or
on page 395
SI Installation and Upgrades
June 2004