Direct Connection Between The Switch And Rfa; No Connection Between The Switch And Rfa - Avaya MCC1 Installation And Upgrades

Install Additional Hardware
Task List: Add Packet Bus Support

Direct connection between the switch and RFA

a
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi"
chapter of the RFA Job Aid, deliver the License File.
NOTE:
This procedure sends the License File to the switch and installs it.
b
If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.

No connection between the switch and RFA

a
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi"
chapter of the RFA Job Aid, deliver the License File to your laptop/PC.
b
Open the License Installation Tool (LIT) application at your laptop/PC.
c
Use the LIT instructions to add a switch connection profile to the tool.
d
Use the LIT instructions to install the License File on the switch.
e
If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
Return to Task List
Test the Packet Bus and C-LAN Circuit Pack (Packet Bus Support)
Return to Task List
Type
test packet port-network 1 long
command section in the appropriate maintenance book.
pkt
Resolve Alarms (Packet Bus Support)
Return to Task List
1
Type
display alarms
2
Examine the alarm log.
3
Resolve alarms using the appropriate maintenance book.
Enable Scheduled Maintenance and Alarm
Notification (Packet Bus Support)
Return to Task List
1
Type
change system-parameters maintenance
2
Enable the scheduled daily maintenance.
3
If you changed the Start Time or Stop Time field, change it back to the original time.
4
Re-enable alarm notification.
592
and press Enter. For more detail about these tests, refer to the
and press Enter.
and press Enter.
SI Installation and Upgrades
test
June 2004