Avaya MCC1 Installation And Upgrades page 378

Install and Connect SCC1 (Single-Carrier Cabinets)
Task List: Install a J58890CG DC Power Distribution Unit
Figure 115: Connections Using DC Power Distribution Unit
Figure notes
1 System Cabinet Stack
2 DC Power Cabinet
3 DC Power Distribution Unit (position
to right of the cabinet stack
4 White Wire (connect to Circuit
Breaker). See inset.
5 Green Ground Wires and Black Wire
(connect to the -48 VDC Return Bus)
6 -48 VDC Bus
7 Inset
378
8 12 inches (30.5 cm) from floor to DC
Power Distribution Unit
9 DC Power Cable to Power Connector on
Each Cabinet.
10 DC Power Distribution Unit Power Cord
(route to rear of DC Power Cabinet)
11 Route Power Cord Through Sliding Door
12 Circuit Breaker
13 Supplied #10-32 Screw, #10 Star Washer,
and #10-32 Hex Nut
14 Inset Showing DC Power Connector
(Male)
SI Installation and Upgrades
June 2004