Avaya MCC1 Installation And Upgrades page 198

Install Fiber Optic Cable Pass-Thru Kit for SCC1 (Single-Carrier) Cabinets
Install the fiber optic cable pass-thru kit (SCC1)
Figure 25: Secure the I/O cable connector
Install the Fiber-optic Cable with the Pass-thru Kit
Return to Task List
CAUTION:
During the actual installation of fiber optic components, use either all beige or all blue
adapters. Beige denotes multimode fiber and blue denotes single-mode fiber. Do not mix
beige with blue.
1
Snap the beige SC-SC fiber optic adapter onto the pass-thru tool. See
adapter and pass-thru tool,
Use the beige adapter even if single-mode fiber is being installed. The beige adapter is better
suited for cable routing in the next steps.
If single-mode fiber is being installed, the beige adapter will be replaced with a blue adapter later.
2
From the front of the cabinet, insert the pass-thru tool into the opening between the bottom of the
circuit packs and the circuit pack label. See
198
on page 200.
Figure 27, Insert the pass-thru tool,
fodatie LJK 041398
Figure 26, Fiber optic
on page 200.
SI Installation and Upgrades
June 2004