Avaya MCC1 Installation And Upgrades page 648

Add IP Solutions
Task list: Upgrade a TN802 to a TN802B
13
Disconnect the monitor, keyboard, and mouse.
Figure 258: TN802B IP Interface faceplate
Figure notes
1 LCD display
2 Reset button (recessed)
3 Red board status LED
Return to Task List
Verify Circuit Packs
Return to Task List
1
Type change circuit-pack
2
On the Figure 259, Circuit Packs - Screen 1,
DSMAPD
3
To correct it, go to the entry just above the TN802B that says
4
Type MEDPRO, and press Enter. Changing the one entry automatically changes the entry above
it. If it is in IP Trunk mode, you get the following error message:
MedPro type requires TN802 with application. Type MEDPRO on circuit-packs
form.
5
To complete the administration, refer to the Administration for Network Connectivity for Avaya™
Communication Manager (555-233-504) book.
648
fpdfmapd KLC 030899
and press Enter.
or .
MEDPRO
1
2
3
4
5
4 PCMCIA card slot
5 Yellow PCMCIA disk-in-use LED
on page 649, check the Code column to see if it says
.
DSMAPD
SI Installation and Upgrades
June 2004