Install and Connect Modems
Task List: Install and Connect Modems
Figure 284: Network Jack on U.S. Robotics Modem
Figure notes
1
Pin 1 of network jack
Return to Task List
Set External Modem Options
Return to Task List
A locally obtained, type-approved external modem may be used. Contact your Avaya representative for
information.
1
Set the modem switches:
•
If a U.S. Robotics Model 839 modem is installed, refer to
Modem Switch Settings
•
If any other modem is installed, refer to the setup instructions provided with that modem. Refer to
SCC1 Modem Fields
2
At the management terminal, enter
3
Scroll to page 3 of the form. Set the Modem Connection: field to external if a modem is
installed. Set the field to none if no modem is installed.
NOTE:
This field must be administered or alarms will be generated. The Modem Connection:
field cannot be set to none if Alarm Origination is activated.
4
Set the Data Bits: field to 8 (default).
5
Set the Parity: field to none (default).
6
For non-United States installations, set the remaining modem fields as shown in
Fields
on page 703.
702
1
modmcabl KLC 110397
on page 703 to set the 8 option switches on the U.S. Robotics modem.
on page 703 while setting up the modem.
2
Modem
U.S. Robotics Model 839 External
change system-parameters maintenance
2
and press Enter.
SCC1 Modem
SI Installation and Upgrades
June 2004